Installing Without The Extension Wing - SawStop tsa-sa48 Installation Manual

INSTALLING WITHOUT THE EXTENSION WING

Modifying your table saw to install the Sliding Crosscut Table Without the Left
Extension Wing:
You will need to shorten your rails to mount the sliding table attachment without the left
extension wing so proceed to step 1 below.
1. Find the seam between the table and the left extension wing (or the left edge of the table if the wing is not
installed). Mark the front rail, rear rail and main tube ¼" to the right of the seam (or edge).
2. Use a 13mm wrench to remove the bolts from the underside of the main tube. Set it aside.
3. Use a 13mm wrench and 5mm Allen wrench to remove the front and rear rails.
4. If the wing is already installed, use either a 17mm wrench (for
to remove the left extension wing from the table saw.
5. For saws only: if you have not yet mounted the switch box assembly to your saw, skip to step 6
below. If your switch box assembly has already been mounted to your saw, use an Allen wrench to remove
the two bolts that mount the switch box bracket to the main table. Allow the switch box assembly to dangle
in place.
6. Use a metal cutting band saw to cut off the front rail, rear rail, and main tube at the marks made in Step 1
above.
7. Remove any burrs or sharp edges with a file.
Using other types of saws (such as circular saw) can generate enough heat to blister the
powder coating. It is strongly suggested that you use a metal cutting band saw only.
8. Remove the plastic end cap from the cut off portion of the main tube and install it on the new left end of the
main tube.
9. If necessary, complete the assembly of your saw (without the left extension wing) but do not mount the
switch box if your saw is a
fence manual).
For ICS and PCS saws, no further modifications are needed, so proceed directly to page
15. For CNS saws without the left extension wing, continue to step 10 on the next page.
or . Next, re-install the front and rear rails and the main tube (refer to your
SLIDING CROSSCUT TABLE INSTALLATION
saws) or 13mm wrench (for saws)
13