Configuration Table - Spectrum Controls Micro 800 User Manual

Bit Name
12, 8, 4, 0 UOR<n>
13, 9, 5, 1 UUR<n>
14, 10, 6,
ULD<n>
2
15, 11, 7, Not
3 Used
WORD
CH0
C:0
Config. Bits
CH0
C:1
High Clamp
Value
CH0
C:2
Low Clamp
Value
Unused C:3
CH1 Config. C:4-7
CH2 Config. C:8-11
CH3Config. C:12-15
CH4 Config. C:16-19
CH5 Config. C:20-23
CH6 Config. C:24-27
CH7 Config. C:28-31
Chapter 3: Configuring the 2085sc-OF8 Using CCW
Description
Unlatch Over Range <channel>
Set this bit to clear the channel over range alarm.
Unlatch Under Range <channel>
Set this bit to clear the channel under range alarm.
Unlatch Load Error <channel>
Set this bit to clear the channel load error alarm.
The LD status bit on the module input table is always active and may be latched
and unlatched any time if the Alarm Latch Enable configuration setting is set.
Bits marked as Not Used have no output control functionality.

3.5.11 Configuration Table

Configuration parameters for each channel are grouped together in a set of 5
words. Detailed descriptions follow.
High Byte
Bits
15 14 13 12
Low Byte
11 10 9 8 7
Signed INT
Signed INT
Unused
(See CH0 Config struct)
(See CH0 Config struct)
(See CH0 Config struct)
(See CH0 Config struct)
(See CH0 Config struct)
(See CH0 Config struct)
(See CH0 Config struct)
User's Manual Pub. 0300308-02 Rev. A
6 5 4 3 2 1
Data
Range
Format
3-19
0