Adjusting The Transmitter Position; Transmitter Housing; Rotate Lcd Indicator - Dual-Compartment Housing - ABB CoriolisMaster FCH400 Series Operating Instructions Manual

40 CoriolisMaster FCB400, FCH400 CORIOLIS MASS FLOWMETER | OI/FCB400/FCH400-EN REV. E
... 6 Installation

Adjusting the transmitter position

Depending on the installation position, the transmitter housing
or LCD display can be rotated to enable horizontal readings.

Transmitter housing

DANGER
Damaging the device carries a risk of explosion!
When the screws for the transmitter housing are loosened,
the explosion protection is suspended.
Tighten all screws prior to commissioning.
Never disconnect the transmitter housing from the sensor.
Only loosen the screws shown when rotating the transmitter
housing!
Rotate transmitter housing: Perform steps
Figure 24: Rotate transmitter housing
Rotate LCD indicator – dual-compartment housing
The LCD indicator can be rotated in three increments of 90°
each. To open and close the housing, refer to Opening and
closing the housing on page 38.
Turn the LCD indicator:
A to C .
Figure 25: Rotating the LCD indicator
Perform steps to .
A F