Single-Compartment Housing; Adjusting The Transmitter Position - ABB CoriolisMaster FCB400 Series Manual

38 CoriolisMaster FCB400, FCH400 CORIOLIS MASS FLOWMETER | CI/FCB400/FCH400-EN REV. H
... 5 Installation
... Opening and closing the housing

Single-compartment housing

1 Cover screws
2 Transmitter housing cover
Figure 20: Open / close single-compartment housing
Open the housing:
• Perform steps and
A
Close the housing:
• Perform steps C and
3 Gasket
.
B
D .

Adjusting the transmitter position

Depending on the installation position, the transmitter housing
or LCD display can be rotated to enable horizontal readings.
Transmitter housing
DANGER
Damaging the device carries a risk of explosion!
When the screws for the transmitter housing are loosened,
the explosion protection is suspended.
• Tighten all screws prior to commissioning.
• Never disconnect the transmitter housing from the
sensor.
• Loosen only the screws indicated when rotating the
transmitter housing!
Figure 21: Rotate transmitter housing
Rotate the housing:
• Perform steps A to C .