ABB CoriolisMaster FCH400 Series Operating Instructions Manual page 104

104 CoriolisMaster FCB400, FCH400 CORIOLIS MASS FLOWMETER | OI/FCB400/FCH400-EN REV. E
... 9 Operation
... Parameter descriptions
Menu / parameter
Device Setup / ...Concentration
The menu is only available if the DensiMass function is activated
Medium
Sub Matrix Selection
Reference Temp.
Device Setup / Variable Matrix
...Configuration
Matrix Name
Unit Name
Concentration Min
Concentration Max
...Matrix 1 Unit
...Matrix 1 Percent
...Matrix 1 Calculation
...Matrix 2 Unit
...Matrix 2 Percent
...Matrix 2 Calculation
Enter Matrix Finish
Device Setup / Variable Matrix / ...Configuration
Number Matrices
Number Temp.
Number Conc.
Enter Conc. in %
Qm / Qv Conc. Switch
Reset Matrix
Description
Selection of measuring medium for concentration measurement using the DensiMass function.
• Variable Matrix
• Sodium Hydroxide
• Alcohol Water
• Wheat Starch
• Corn Starch
• Sugar in H2O
• °API Gravity
Selection of sub-matrix for concentration measurement.
Only available if the matrix selected from Medium has two sub-matrices.
Sets the reference temperature for calculating process variables Vol.Flow@Tref and Density@Tref [unit].
Selection of submenu '...Configuration' using
Entry of a name for the variable matrix.
Entry of a unit name for the variable matrix.
Entry of the maximum permissible concentration.
Entry of the minimum permissible concentration.
Selection of submenu ''...Matrix 1 Unit' to enter Matrix 1 using
See chapter Concentration measurement DensiMass on page 125 for further information.
Selection of submenu '...Matrix 2 Unit' to enter Matrix 2 using
See chapter Concentration measurement DensiMass on page 125 for further information.
Selection of number (1/2) of the matrices.
Entry of the number of temperature values.
Entry of the number of concentration values.
Selection of whether the concentration value must be entered in %.
• Yes: Entry of the concentration values in %
• No: Entry of the concentration values in a selected unit.
NOTICE
A net flow cannot be calculated if the concentration has only been entered in a unit. To enable the net flow to be calculated,
the concentration must also be entered in %.
Selection of whether the entered concentration values are volume or mass concentration values. The values are used to
calculate the mass flow or volume flow rate.
• Mass Concentration
• Volume Concentration
All entered matrix values are reset to '0'.
.
.
.