ABB CoriolisMaster FCH400 Series Operating Instructions Manual page 101

CoriolisMaster FCB400, FCH400 CORIOLIS MASS FLOWMETER | OI/FCB400/FCH400-EN REV. E
Menu / parameter
Device Setup / ...Transmitter
...Units
...Custom Units
Damping Qm
Damping Density
Density Mode
Density Fixed Value
......Cut Off
TX Location TAG
TX TAG
Plant Data Sync.
Device Reset
Restore Settings
...Feature Settings
Description
Selection of submenu '...Units' using
Selection of submenu '...Custom Units' using
Sets the damping for measuring mass flow. The value set here relates to 1 τ (Tau). The value refers to the response time for
a stepwise mass flow change.
Sets the damping for measuring density. The value set here relates to 1 τ (Tau). The value refers to the response time for a
stepwise density change.
Selection of operating mode for density measurement.
• Density Measured: The density of the measuring medium is calculated by the transmitter.
• Density Fixed Value: The density of the measuring medium is specified as a constant in parameter 'Density Fixed Value'.
The 'Density Fixed Value' operating mode can be used to enable standard volumes to be calculated. See also chapter
Measurement of standard volumes on page 122.
Sets the density of the measuring medium, for example, when measuring the standard volume of gases.
Selection of submenu '......Cut Off' using
Entry of the measuring point tag for the transmitter.
Alphanumeric, max. 20 characters
Entry of the TAG number for the transmitter.
Alphanumeric, max. 20 characters
The transmitter saves its configuration in the 'SensorMemory'. The data is stored redundantly on the motherboard (MB) of
the transmitter and on the frontend board (FEB) of the sensor. This means the configuration can be restored quickly if any
components are replaced.
• FEB > MB: Loading the configuration from the frontend board (FEB) of the sensor.
• MB > FEB: Loads the configuration from the motherboard (MB) of the transmitter.
See also chapter Replacing the frontend board on page 141.
Restarts the device. Compensates for a short interruption of the power supply.
All user-accessible parameters will be reset to the factory default settings.
Selection of submenu '...Feature Settings' using
.
.
.
.
101