Span Data; Max Liquident; Min Liquident; Max Roc - Siemens SITRANS F FUH1010 Series Operating Instructions Manual

Section 2
Use this menu to set the
low and high range for
analog outputs.
Use this menu to set the
Interface Alarm
parameters.

2.6.1 SPAN DATA

The [Span Data] menu allows you to set 0% and 100% output limits for Sonic Velocity (Vs),
Specific Gravity (SG ), Temperature, Viscosity (cS), and API numbers. Each menu cell shows
appropriate units. The computer automatically updates the output data setup to reflect the
change. Note that Span limits apply to the analog outputs.

Max LiquIdent

The [Max LiquIdent] menu cell stores the maximum range value for the LiquIdent function.
To enter the Max LiquIdent range setting:
To activate numeric entry press
Use numeric keys or Magnetic Wand to enter the maximum range (100% of range).
To store the data press

Min LiquIdent

The [Min LiquIdent] menu cell stores the minimum range value for the LiquIdent function.
To set the Min LiquIdent range setting:
To activate numeric entry press
Use numeric keys or Magnetic Wand to enter the minimum range (0% of range).
To store data press
The following Span Data items are set in the same way as the two previously shown examples
by entering numeric values and storing the data.

Max ROC

The [Max ROC] menu cell stores the maximum rate of change range value for the LiquIdent
function.
Controlotron Dual Path
Span 0% and 100% Values for Analog Data
Span Data
Set Alarm Levels
Interface Alarms
Data Span/Set/Cal
ENT
ENT
2-36
1010BXFM-3
SITE 1
Use this menu to define
setpoints for the alarm
relay outputs.