Liner Material; Liner Thickness; The Application Data Menu - Siemens SITRANS F FUH1010 Series Operating Instructions Manual

Section 2
NOTE: Do not use ASA schedule code to specify the wall thickness. You must enter
actual dimensions. We recommend that you use the 1011TS Thickness Gauge
to obtain an accurate dimension.
To enter the Pipe Wall Thickness:
To enable numeric entry press
Use the numeric keys or Magnetic Wand to enter exact wall thickness (use in/mm).
To register the pipe wall thickness press

2.2.6 LINER MATERIAL

For lined pipes, select a pipe liner from the material option list. If the pipe liner material does
not appear on the list then select the closest type available. If necessary, call Controlotron
Customer Service for additional help. The system default [Liner Material] is [None]. If the
pipe does not have a liner, press
The [Liner Material] option list offers a selection of common liner materials.
To select a Liner Material:
To access the [Liner Material] option list press
To scroll to the required [Liner Material] press
To register selection press

2.2.7 LINER THICKNESS

If you specified a pipe liner in the [Liner Material] menu cell, then use this menu cell to set its
exact thickness in appropriate units (English or Metric).
To enter a Liner Thickness:
To enable numeric entry press
Use the numeric keys or Magnetic Wand to enter the exact liner thickness value.
To register the data press
2.3

THE APPLICATION DATA MENU

This menu becomes available after picking a Meter Type, Measurement Channel and Mea-
surement Technology. Use of this menu is optional.
CAUTION: An erroneous Viscosity entry could affect the meter's intrinsic calibration.
Do not alter the default viscosity value of your liquid unless you are sure
of your data.
ENT
twice to bypass to the next two menu cells.
ENT
ENT
2-10
1010BXFM-3