Accessing And Leaving The Menu - Siemens SITRANS F FUH1010 Series Operating Instructions Manual

Section 1

1.11.1 ACCESSING AND LEAVING THE MENU

When you first apply power to the meter, there will be a 20 to 30 second delay and then you
will see a scrolling banner and a copyright notice appear on the LCD panel display. This
means that the meter requires a new (or stored) site setup to be loaded into its active memory
(active memory will be explained later). The first time you access the Installation Menu, you
can leave it only by saving a site or by turning the meter off. After installing and activating a
site, use the ENTER sensor to toggle between the display screen and the last accessed menu
location.
To access the Installation Menu:
Make sure the Menu Lockout Switch is in the unlocked position (see paragraph 1.10).
Momentarily place the Magnetic Wand tip over the [ENTER] switch (located above the
target symbol). This accesses the top level of the Installation Menu, as shown in the follow-
ing figure. Note that the top line of the LCD display shows the currently selected menu
[Meter Type] and that the second line shows [Single Channel] preceded by the "greater
than" symbol (>).
Top level of
Installation
Menu
Current Selection
Triggering the ENTER sensor now would switch the "greater than" symbol to a colon (:). The
colon indicates that the data listed on the second line can be edited. This convention applies
to all menu cells that provide option lists throughout the Installation Menu. If the menu cell
requires a numeric value, the ENTER sensor switches the "greater than" (>) character to an
equal sign (=) instead. The equal sign indicates that you can edit the numeric value.
Controlotron
0 0
copyright 2005
Meter Type
>Single Channel
1-10
LCD panel display showing
initial screen with copyright
notice.
ENTER Switch
ENTER Target Symbol
1010BXFM-3