Main Diagnostics Screen; Diagnostic Main Menu Description; Path Select; Path Enable (N/A) - Siemens SITRANS F FUH1010 Series Operating Instructions Manual

Section 2
2.9.1

MAIN DIAGNOSTICS SCREEN

This is the Main Diagnostics Data screen. It provides menus that show Path Select, Path
Enable, Signal Data, Application Info, Liquid Data, Site Setup Data information. In addition,
the Test Facilities menu provides test/control functions to optimize operation, analyze appli-
cation conditions and to recover system operation. Also included are Print Site Setup and
Date Site Setup menus. As shown below, diagnostics provides nine menus and two menu cells:

Path Select

Path Enable
Signal Data
Application Info
Liquid Data
Site Setup Data
Test Facilities
Print Site Setup
Date Site Created
2.9.2 PATH SELECT
The [Path Select] menu cell allows the selection of individual path diagnostics. Selecting Path
[1] or Path [2] will display the entire Diagnostic List.
To select the Path Select function:
To access [Path Select] press
To select Path [1] or Path [2] press
To store the selection press
Controlotron Dual Path
Select Diagonostics Data Display Source
Path Select
Path Enable
Signal Data
Application Info
Liquid Data
Site Setup Data
Test Facililties
Print Site Setup
Date Site Created
I/O Data Control

DIAGNOSTIC MAIN MENU DESCRIPTION

This meau allows selection of Path 1 or Path 2.
This menu enables the selected Path.
This menu shows Signal specific data.
This menu shows current meter operating status.
This menu shows current RTD temperature readings among others
(if this system includes optional RTD Temperature measurement cap-
ability).
This menu shows current transducer setup data and signal status.
This menu provides system test and recovery routines.
This Menu cell allows you to send an ASCII dump of the current Site.
Data to a RS-232 port device (e.g., a printer or laptop computer).
This menu cell shows date and time when the current site was created.
ENT
SITE 1
1 and 2
No
08.11.9911.99 12.48.58
2-52
1010BXFM-3