Siemens SITRANS F FUH1010 Series Operating Instructions Manual page 5

Errata
NOTE: The input power connector consists of a removable wire plug and PCB header located on
the 1010X-8 I/O module. Two screws secure the wire plug to the header. The connector assembly
is fully polarized for fast and easy mating. The wire plug accepts stranded or solid conductors of
AWG 12 - 18. To insert a wire into the wire plug, strip back the insulation by 0.31" (8 mm), loosen
the wire clamp screw, insert the stripped wire end and then re-tighten the wire clamp screw.
Plug input power connector P8 into connector J8 and secure using two captive connector
mounting screws as indicated above.
Secure power-input cable with cable clamp to prevent wire breakage.
Replace Rear Housing Cover and tighten setscrew.
Connect the power cables to the appropriate power source previously selected from the tables
above and power up unit.
If unit is operational, turn power off and install transducer cables.
2.3 THE MENU LOCKOUT SWITCH
System 1010X includes a menu lockout switch to prevent unauthorized access to the Installation
Menu. In addition, a password entry option is available (see Channel Setup). The menu lockout
switch (S1) resides on the I/O module on the right side of I/O wiring terminal block TB1 (see
below). Please switch to the unlocked position before attempting to program the flowmeter. We
recommend that the installation menu remains locked during normal operation. (Refer to appro-
priate manual section for TB1 and TB2 signal wiring.)
Siemens Hardware
Menu Lockout
Switch (S1)
E-3
1010FMA-45