Download  Print this page

Mounting/Dismounting Cross Connectors; Mounting/Dismounting Swivel Label Holders - Honeywell CENTRA LINE LION CLLIONLC01 Installation & Commissioning Instructions

Hide thumbs


LION System

Mounting/Dismounting Cross Connectors

The long cross connector (incl. in the scope of the delivery)
can be mounted to the XS824-25 or XSU824-25, as
required (Fig. 29). It can be dismounted (see Fig. 28) and, if
desired, replaced with one or two short connectors (optional
accessory, see Table 5 on page 7). It is not permitted to
replace these cross connectors with wire.
Insert a screwdriver on one end of the cross connector
and swivel it to the right and to the left.
Insert a screwdriver on the other end of the cross
connecter and swivel it to the right and to left until the
cross connector is released.
If desired, insert another cross connector.
Fig. 28
Dismounting the cross connectors (long cross
connector shown here)
Fig. 29
Mounting the cross connectors (short cross
connector shown here)
Mounting/Dismounting Swivel Label
A swivel label holder is included in the scope of delivery of
each module.
Use only the (short / long) swivel label holders appropriate
for the given type (pluggable or mixed, respectively) of I/O
Mounting Swivel Label Holders
Snap the swivel label holder onto the hinges of the
terminal socket / mixed I/O module.
Apply self-adhesive labels to the holders.
Fig. 30
Mounting the swivel label holder
Dismounting Swivel Label Holders
Press the hinges together and remove the swivel label
Mounting/Dismounting Modules
EN1Z-0921GE51 R0709



  Related Manuals for Honeywell CENTRA LINE LION CLLIONLC01