Smartbox Controller™ Diagram; Mounting - Honeywell SMARTBOX Owner's Manual

9
SMARTBOX™ Controller Diagram

Mounting

SMARTBOX™ Controller for HONEYWELL™ Wind Turbine WT6500 Owner's Manual - Rev14
CHARGER DSP CONTROL
OVP
CHARGE
CONTOL
IO BOARD
CURRENT/ CURRENT/
VOLTAGE VOLTAGE
SENSING SENSING
SYSTEM
POWER
DC
GFI
EQUIPMENT
GROUND
WIND TURBINE 24V
HV POWER BATTERY
INPUT BANK
FROM TURBINE
Figure 2.2 SMARTBOX™ Controller Diagram
The SMARTBOX™ Controller must be mounted vertically and installed indoors in a
dry, protected location away from flammable material, sources of high temperature,
moisture and vibration. The location must also be sheltered from direct sunlight, rain,
snow and wind-blown debris.
It is best to mount the SMARTBOX™ Controller near near the building's electrical
panel egress. This will typically result in the SMARTBOX™ Controller being mounted
on or near an external wall where the battery enclosure can then be located outdoors.
RISK OF FIRE OR EXPLOSION
To reduce the risk of fire or explosion, do not install
the SMARTBOX™ Controller in sealed compartments
containgin batteries or in locations that require ignition-
protected equipment. Failure to follow this warning may
result in death, personal injury or property damage.
Get other manuals https://www.bkmanuals.com
INVERTER
AC
TRANSFER
SWITCH
CURRENT/ CURRENT/
VOLTAGE VOLTAGE
SENSING SENSING
ISOLATED
LOGIC
CONTROL
TURBINE
RS485 AC OUT AC GRID
LOGIC
CONTROL
SMARTBOX Installation