Mounting/Dismounting Modules
Mounting/Dismounting Cross Connectors
Note
The long cross connector (incl. in the scope of the delivery)
can be mounted to the XS824-25 or XSU824-25, as
required (see Fig. 29). It can be dismounted (see Fig. 28)
and, if desired, replaced with one or two short connectors
(optional accessory, see Table 5 on page 7). It is not
permitted to replace these cross connectors with wire.
Insert a screwdriver on one end of the cross connector
►
and swivel it to the right and to the left.
Insert a screwdriver on the other end of the cross
►
connecter and swivel it to the right and to left until the
cross connector is released.
If desired, insert another cross connector.
►
Fig. 28
Dismounting the cross connectors (long cross
connector shown here)
Fig. 29
Mounting the cross connectors (short cross
connector shown here)
EN1B-0375GE51 R0910
Mounting/Dismounting Swivel Label
Holders
Note
A swivel label holder is included in the scope of delivery of
each module.
Use only the (short / long) swivel label holders appropriate
for the given type (pluggable or mixed, respectively) of I/O
module.
Mounting Swivel Label Holders
Snap the swivel label holder onto the hinges of the
►
terminal socket / mixed I/O module.
Apply self-adhesive labels to the holders.
►
Fig. 30
Mounting the swivel label holder
Dismounting Swivel Label Holders
Press the hinges together and remove the swivel label
►
holder.
22
Excel 800