About Screw Terminal Connectors; Reader Input 2 - Honeywell SEC-H-602 Manual

READER INPUT 2

(WIEGAND 12V
TYPE)
OPTION SLOT
2 AREA
NIMH BATTERY
PACK CONNECTOR
(SEE FIG. 15 ON
PAGE 26)
6 PIN END
CONNECTOR
(EXPANSION
MODULES)
OPTION SLOT
CONNECTORS
OPTION SLOT
1 AREA
EARTH GROUND
CONNECTOR LUG
UNSUPERVISED DIGITAL
INPUTS (1-3) ONE
4-POSITION CONNECTOR
Fig. 4. Security Controller (SEC-H-602 or SEC-H-616) board layout details.

About Screw Terminal Connectors

Screw-terminal connectors are shipped loose in a
separate hardware bag. If desired, you can make wiring
terminations to connectors before installing on the
Security Controller circuit board pins. Please note the
following:
• When you install a connector onto the board pins,
terminal labels (on the circuit board) are covered.
EACH HAS ONE READER INPUT 1
7-POSITION (WIEGAND 12V
CONNECTOR TYPE)
SECURITY
CONTROLLER
NIMH BACKUP
BATTERY AND
BRACKET
DIGITAL SUPERVISED
INPUTS (1-6) THREE
3-POSITION CONNECTORS
SEC-H-602 AND SEC-H-616 SECURITY CONTROLLER
FORM-C RELAY OUTPUTS 1-4 TWO
6-POSITION CONNECTORS
STATUS LEDS (VISIBLE WITH COVER ON)
LAN1 BEAT
STATUS
LAN2
PRIMARY
ETHERNET
RS-232
(RJ-45)
(DB-9)
LAN1
COM1
• Once installed, removal of larger connectors (readers,
relay outputs) may be difficult, especially if wiring has
been landed. Here, removal is recommended only if
replacing the device.
In general, it may be easiest to wire to loose connectors
(held next to pins), then install them after completing.
11
LEDS FOR
RELAY
OUTPUTS
MODE JUMPER
(FOR SERIAL
SHELL ACCESS)
LEDS FOR COM1
(RS-232) AND
COM2 (RS-485)
12VDC SLA
FOR EXTERNAL
15VDC SUPPLY BACKUP BATTERY
(ONE 4-POSITION CONNECTOR)
6 PIN END
CONNECTOR
(EXPANSION
MODULES)
INCLUDES
RS-485
M35014
31-00012—03