Honeywell CENTRA LINE LION CLLIONLC01 Installation & Commissioning Instructions page 76

Troubleshooting
L W Service LED
ON ORKS
Fig. 109 Flashing pattern of the L
The L W service LED of the controller module displays the following flashing patterns indicating possible failure modes:
ON ORKS
case When can it occur?
1 Anytime
2 Power up of controller
3 Power up of controller
4 Power up / reset
5
Anytime
6 Anytime
Table 73 CLLIONLC01 L
EN1Z-0921GE51 R0709
W service LED
ON ORKS
Meaning
Node is configured and running normally
Bad node hardware
Bad node hardware
Node lacks application.
May be caused by neuron chip firmware when
a mismatch occurs on application checksum
Watchdog timer resets occurring.
Possible corrupt EEPROM and bootstrap
mode
Node is unconfigured but has an application
W service LED
ON ORKS
Remedy
No action necessary
Replace hardware
►
Replace hardware
►
Using EXCELON, set module to
►
"configured online"
If the problem persists, the MIP
►
software on LW interface has been
erased due to wrong setting
performed using ECHELON tool:
Replace hardware
Download firmware
►
Proceed with commissioning
►
76
LION System