Trane TR200 Programming Manual page 132

8-1* Ctrl. Word Settings
Parameters for configuring the option control word profile.
8-10 Control Profile
Option:
[0] * FC profile
[1] PROFIdrive profile
[5] ODVA
[7] CANopen DSP 402
8-13 Configurable Status Word STW
Option:
[0] No function
[1] * Profile Default
[2] Alarm 68 Only
[3] Trip excl Alarm 68
[16] T37 DI status
8-3* Adjustable Frequency Drive Port Settings
Parameters for configuring the Adjustable Frequency Drive Port.
8-30 Protocol
Option:
[0] * FC
[1] FC MC
[2] Modbus RTU
[3] Metasys N2
TR200 Programming Guide
Function:
Select the interpretation of the control and status words corresponding
to the installed serial communication bus. Only the selections valid for
the serial communication bus installed in slot A will be visible in the
keypad display.
Function:
This parameter enables configuration of bits 12 – 15 in the status word.
Function corresponds to the profile default selected in par.8-10
Profile.
Only set in the event of Alarm 68.
Set in the event of a trip, except if the trip is executed by Alarm 68.
The bit indicates the status of terminal 37.
"0" indicates T37 is low (safe stop)
"1" indicates T37 is high (normal)
Function:
Protocol selection for the integrated FC (standard) Port (RS485) on the
control card.
Parameter group 8-7* is only visible when Adjustable Frequency Drive
Option [9] is chosen.
Communication according to the FC protocol as described in the TR200
Design Guide, RS 485 Installation and Set-up
FC
Same as [0] but to be used when downloading SW to the adjustable
frequency drive or uploading dll file (covering information regarding pa-
rameters available in the adjustable frequency drive and their inter-
dependencies) to Trane Drive Utility, TDU.
Communication according to the Modbus RTU protocol as described in
Design Guide, RS 485 Installation and Set-up
the TR200
Communication protocol. The N2 software protocol is designed to be
general in nature in order to accommodate the unique properties each
Parameter Description
Control
.
.
4-95