Table of Contents
Advertisement
Counters Menu
(Main Menu > Configure > Setup > Edit Setup > Events/Counters > Counters)
Up to 16 User Counters are available and can be used as a part of the Events system. User
Counters can be set up as a Cause or an Effect of an Event.
Once a User Counter is setup it has to be assigned something to count eg. as a part as an
Event.
43-TV-25-35 GLO Iss.4 Dec 06 UK
A5E01001767-04
• • Resume - this can be used after the chart has been stopped or paused. The
chart data will continue from where it has been paused with no gaps displayed.
But if the chart has been stopped the displayed data will display a gap in data
until it is resumed
• • Clear - this will clear all the data from the chart being displayed. Data will not
be cleared if the chart has been stopped. This will not clear recorder data from
the memory, only the chart.
• • Prefill - this will clear the chart and then fill it with the current reading. A
stopped chart cannot be prefilled.
• Clear All Messages - this will clear all the messages in the message list.
sages Menu" on page 122.
Setup a User Counter
Select the next available Counter number.
• Enabled - In the Counter # menu tick to Enable.
• Name - Name the counter for ease of identification.
• Start At - Enter the number at which you want the counter to Start At
• Rollover - Enter the number at which you want the counter to Rollover At. The default
maximum Rollover value is 3.3e+38. When the count reaches the rollover number
entered it will restart the count from your Start At number
See "User Counters" on page 83.
Power up
See "Mes-
89
Advertisement
Table of Contents
