Table of Contents
Advertisement
The rear of the recorder is fitted with an Ethernet10/100 port and RS485 port, which sup-
ports:
(A Comms option card and expansion card are required for the SIREC D200 recorder
The RS485 connector plugs into the back of the recorder. This is a Master-Slave system
where the recorders are slave devices.
The front and rear of the SIREC D300 and SIREC D400 recorders are fitted with a USB
communication port.
and another available at the rear as an option.
The USB Host ports will provide an interface for:
74
• Modbus - Communications protocol for Ethernet and RS485.
page 75.
• Web -Browse your recorder using the web browse feature.
• Email - Setup email accounts to send alarm and event information.
page 76.
Simple Network Time Protocols is a protocol for synchronising the clock
• SNTP -
on the recorder with a Network Server.
• FTP (File Transfer Protocol) - used to transfer data to and from the recorder.
"FTP (File Transfer Protocol)" on page 78
• Peers - Sets up the recorder to be identified on a network (Peer to Peer).
"Peers" on page 79.
Standard Communication Interfaces
Rear Ethernet Communication Port
• RS485 Modbus protocol and TCP/IP Modbus.
See "Web" on page 75
• Web Browser.
• OPC Server connectivity to third party software. OPC Server connection must be ena-
bled by selecting the OPC option in
"OPC Interface - Open Process Control" on page 198
Servers see
Rear RS485 Port
• RS485: 2 wire to support Modbus RTU.
Front and Rear USB Communication Ports
SIREC D200 recorder has a USB port at the front, as standard
The
• Save and Load Data
• Save and Load Setups
• External keyboard & mouse
• Barcode reader
• Mass storage device (USB key)
Power up
See "SNTP" on page 77.
"Credits" on page 92.
See "Modbus" on
See "Web" on page 75.
See "Email" on
See
.
See
For more details on OPC
).
43-TV-25-35 GLO Iss.4 Dec 06 UK
A5E01001767-04
Advertisement
Table of Contents
