Analogue Output Channel Numbers
The Analogue Output cards are either 2 or 4 channels using a connector that only takes up
half the length of the connector slot. Looking from the rear of the unit the Analogue Out con-
nector is on the left of the Analogue slot with a blanking plate on the right.
Analogue Output Connection Details
Pulse Input Card
The
into a PCB header on the rear of the unit.
The Pulse Input card position for the SIREC D300 is shown in
and
The Pulse Input card is not available on the SIREC D200
O option card has 4 channels that can be set as pulse inputs (channels 1 to 4). The operat-
ing frequency for pulse inputs on the Digital I/O card is 1kHz max.
Input: Low < 1V, High >4V to <50V DC (8V to 50V p-p AC) or Volt free input: Low = short
circuit, High = open circuit.
22
Electrical Installation
Card Position
Channel number
Output 1
Output 2
1
2
3
4
Loop -
NC
Loop +
Loop -
connections are made via 1 x 12-way screw terminal plugs that fits
Pulse Input card
Figure 2.4 on page 15
Table 2.4 :
Analogue Output card
Slot B
9 to 12
33 to 36
Output 3
5
6
7
8
9 10 11 12
Loop +
Loop -
NC
NC
Loop +
Loop -
for the SIREC D400.
Slot E
Slot F
41 to 44
Output 4
Loop +
NC = Not
NC
connected
Figure 2.3 on page 14,
the 8 Digital I/
recorder, however,
43-TV-25-35 GLO Iss.4 Dec 06 UK
A5E01001767-04