Table of Contents
Advertisement
Program recording
Desired CD tracks can be programmed in the desired sequence and recorded onto a tape.
Do not use a cassette tape with more than 90-minute recording time, for the tape used with such a cassette is very
thin and tends to cause troubles such as entanglement around the pinch roller or cutting of tape.
Be sure to put the cassette deck in stop mode.
1
Make the preparations for recording.
1 Perform steps 1~3 of the procedure in "Recording
on TAPE".
2 Select the "CD" input.
3 Load the recording source disc in the CD player.
2
Check the current play mode of the CD player.
If it is in play mode, stop it.
7
STOP
3
Program the desired sequence of CD tracks.
Perform steps 2 and 3 of the procedure in "Lis-
tening in the desired sequence (Program play-
back)".
4
Start recording.
CD=TAPE
To interrupt a recording
Press the 7 (stop) key on the main unit or 7 STOP
key on the remote. (This stops both recording and
playback.)
(PGM mode + O.T.E.)
‚
¢
¢
u
Convenient recording of CD player output
=
CD
TAPE
This system can record signals on Normal (TYPE ) and
High (TYPE ) position tapes. Remember that the Metal
(TYPE
) tapes cannot be used with this system.
÷ Recording begins from the first track in the program and
completes when the entire program has been recorded.
÷ When either the playback or recording operation stops, the
other operation also stops.
÷ When you are operating the main unit, select "O.T.E. Mode"
in the menu mode then select "CD=
SET key to start recording.
÷ When recording completes, the tape stops after leaving a no-
sound blank of about 4 seconds.
65
= = TAPE" and press the
= =
Advertisement
Table of Contents
