Kenwood HM-982RW Instruction Manual page 41

When CD has been selected.
6
CD 4 4
The source connected to the DIGITAL
IN OPTICAL jack cannot be recorded
onto tape. To record an external
source on tape, connect the source
component's output to the AUX IN
jacks and select the "AUX" input
source.
TAPE REC
Lights
6 6
Pause the recording (Main unit only)
TAPE REC
÷ Press the TAPE REC key during recording. It stops after
leaving a non-recorded blank of 4 seconds. (Press the key
again to resume recording.)
÷ The "
" display blinks and the TAPE REC indicator also
DECK
blinks.
4. Select the source to be recorded.
TUNER (Broadcasts) : Press the TUNER/BAND key
CD (CD player)
CDR (CD recorder)
AUX (Auxiliary analog source)
÷ When CD 6, CD-R 6 is pressed, playback will
start when a disc already has been inserted. Press
the 7 STOP key to stop it.
5. Make the preparations for recording.
TUNER (Broadcasts) : Select a station
CD
CDR
AUX (Auxiliary analog source)
÷
The input level can be varied only when the "AUX" (auxiliary analog source)
input is selected. Adjust the input level from the auxiliary source as required
if it is too small or too large. (AUX Input, Rec Gain)
6. Start recording.
1 When the preparation is complete, press the TAPE REC key.
(this starts actual recording)
2 Play (or tune) the music source to be recorded.
÷ If you want to also record the input on a CD-R/RW at the same time, press the CD-
R REC key in step 1, wait until the blinking rate of the CD-R REC indicator slows
down, then press the CD-R REC key again.
÷ "
" is displayed and the TAPE REC indicator starts to light steadily.
DECK
÷ Recording stops automatically when the tape side(s) to be recorded have been fully
recorded.
Stop the recording
÷ If the key is pressed during recording from a CD, the CD
÷ If the key is pressed during recording from CDR, the CDR
÷ The same function is also available using the 7 STOP key on
: Press the CD 6 key
: Press the CD-R 6 key
: Press the AUX/D-AUX key repeatedly until "AUX"
is displayed.
: Enter pause mode at the beginning of the track
to be recorded.
: Enter pause mode at the beginning of the track
to be recorded.
: Make preparation for tuning or playback. f
7
playback also stops.
playback also stops.
the remote control unit.
41
Recording on TAPE
C D 0 1
0 : 0 0
SINGLE
The selected recording
source is displayed.
w