(Cd (Cdr) - Kenwood HM-982RW Instruction Manual

62
Program recording
The Twin Recording makes is possible to record desired CD tracks programmed in the desired order onto a CD-R/RW
simultaneously. (High-speed recording is not available.)
The recording source can be a finalized CD-R/RW, but digital-to-digital recording may not be available with certain
discs."Digital recording and SCMS"
Select the "CD" input. Be sure to put the CD recorder in stop mode.
Before recording
When digital-to-digital recording is not impossible
or when analog-to-digital recording is performed,
select the analog input as described in the follow-
ing section then start the setting from step 1
below."Changing the recording input setting"e
1
Make the preparations for recording.
1 Place a recordable CD-R or CD-RW disc.
2 Load the recording source disc in the CD player.
3 Make sure that the "High" (high-speed dubbing
indicator) in the display is not lit.
2
Check the current play mode of the CD player.
If it is in play mode, stop it.
3
Program the desired sequence of CD tracks.
Perform steps 2 and 3 of the procedure in "Lis-
tening in the desired sequence (Program play-
back)".
4
Start recording.
CD=CDR
(PGM mode + O.T.E.) (Norm)
fl
¢
7
u
Convenient recording of CD player output
=
CD CDR
DIGITAL
The current setting is displayed.
"DIGITAL" is lit ............. Digital-to-digital recording
"DIGITAL" not lit: ......... Analog-to-digital recording
÷ When a CD-R/RW is loaded in the CD recorder, the CD-R IN
indicator may blink for a while.
"OPC (Optimum Power Control)"
÷ If the "HIGH" is lit in the display, turn it on by selecting "O.T.E.
Speed" in the menu mode, selecting "<Norm>" and press-
ing the SET key.
÷ High-speed recording is not available in the PGM mode.
÷ Recording starts with the first programmed track until all the
programmed tracks have been recorded.
÷ When either the CD program playback or CDR recording
operation stops, the other operation also stops.
÷ When you are operating the main unit, select "O.T.E. Mode"
in the menu mode, then select "CD=
press the SET key to start recording.
÷ With certain discs, digital-to-digital recording may be prohib-
ited by SCMS (A). Such a disc should be recorded using
the analog output signal.
A
‡
= = CDR <Norm>" and = =
e