Clock Adjustment - Kenwood HM-982RW Instruction Manual

Clock adjustment

This unit incorporates a clock function. Be sure to ad-
just the correct time before using the timer function.
If there is a power failure or the power cord is
unplugged then plugged in again while the power is
set to off (STANDBY mode) after a timer is activated,
the STANDBY/TIMER indicator blinks in green. In
this case, adjust the clock again.
Switching the power ON
1
Activate the clock adjustment mode.
Press and hold for more than 2 sec.
MENU
2
Enter the hour.
1 Adjust the figure of hours by pressing the MULTI
CONTROL keys.
To advance
the time
CONTROL
To put back
the time
2 Press the SET key.
3
Enter the minute.
1 Adjust the figure of minute by pressing the MULTI
CONTROL keys.
To advance
the time
CONTROL
To put back
the time
2 Press the SET key.
When power is OFF (standby) :
Pressing the 7 (stop) key on the main unit or the 7
STOP key on the remote displays the time for 5
seconds.
MULTI
SET
MULTI
SET
÷ The time display starts to blink.
T I M E
\
A d j u s t
1 Setting the hour
1 3 : 0 0
Blinks
÷ Press the SET key. The hour is entered and the minute
display starts to blink.
÷ The clock shows the time of the day in the 24-hour system.
1 Setting the minute
1 3 : 3 0
Blinks
÷ If you pressed the SET key by mistake, press the MENU key
and restart from the beginning.
÷ To adjust correct time, press the SET key at the same
moment as a time announcement.
19
Menu mode
0 : 0 0
Blinks
Example for adjusting at
1:30PM