Recording Favorite Tracks From Cd Onto A Single Tape (Program Edit Recording) - Kenwood XD-8551 Instruction Manual

54
Recording favorite tracks from CD onto a single tape
(Program edit recording)
Use the following procedure to record CD tracks in the order programmed by yourself so that no tune is interrupted in the
middle at the ends of tape sides.
The tune interrupted at the end of tape side A is erased and side B starts from the beginning of that tune.
When equalizer, SRS 3D or another effect is applied
to the sound, the sound with the applied effect can
be recorded.
Recording preparations are required. ¤
1
Press so that the "PGM" indicator lights.
2
Enter disc Nos. and track Nos. in the order you want to record them. (Editing)
1 Enter the disc No. (DP-MH5 only)
Go to step 2 within 8 seconds.
2 Enter the track No.
3 Press the P.MODE key to enter the
selection in memory.
For the systems including the DP-H5:
Program other tracks by repeating steps 2 and 3 for each.
For the systems including the DP-MH5:
If you program tracks from more than one CD, repeat steps 1
to 3 for each.
To check the edited contents
To clear the edited contents
3
Start edit recording.
O p π
1. When the CCRS key is pressed during playback of CD, the playback stops and the CCRS setting (preparation for edited recording) starts.
2. Edit recording is not possible with CDs containing a track that is longer than one tape side, which may occur with classical music, etc.
Notes Notes
3. If the deck is set for one-side recording ("), the processing at the tape end is applied only on side A.
OP
¤ ¤ ¤
¤
For the reverse mode, select ""","[" (two-way recording).
P.MODE
DISC SKIP
Go to step
3 within
1 2 3
8 seconds.
4 5 6
7 8 9
PTY
SEARCH
0 +10
Y
Y
Blinks
CCRS
For C-H6: Character information indicators cannot be dis-
Note
Note played while the spectrum analyzer display is used. Switch
to the dual display or character display mode to see the
information.
Lights
PGM MEMO
AUTO
TUNED
The selected disc number is dis-
played when the DP-MH5 is used.
PGM MEMO EDIT RDS EON TA NEWS
C D *
AUTO DISC ALL
TUNED STEREO
MAX
Press the numeric keys as shown below....
To enter track No. 23 : 003
To select track No. 40 : 0000)
÷ Select CD tracks so that their total playing time does not exceed the
recording time of the tape.
÷ Up to 32 tracks can be programmed. When "FULL" is displayed, no
more tracks can be programmed.
÷ If you make a mistake, press the CLEAR key and enter the track No.
from the beginning.
÷ When the P.MODE key is pressed without selecting a title after
selection of a disc, all titles of the disc are programmed, so that the
CCRS function does not operate. Please begin again from step 1.
÷ The REPEAT key is invalid.
During recording: X-H5
÷ The recording level and bias will be adjusted automatically in approx. 60
seconds (variable depending on CD contents), after which recording
starts.
÷ For the systems including DP-MH5: In editing from more than one CD,
the CCRS setting operation is performed after every disc change. In this
case, the deck stops automatically and restart recording after having
completed the CCRS operation.
Convenient CD recording
XD SERIES (En/E2)
!´
EDIT RDS EON TA N
C D *
DISC ALL
STEREO
MAX
SLEEP O.T.T
Track No.
Program No.
INFO. TP PTY TOTAL SPACE PROG. MUTE
) 3 * P - ) : 1
12
3
kHz 2
1
MHz
8
6 7
11 12 13
Blinks Lights
REC / ARM
CCRS
N.B.
5
4
10
9
14 15