Recording Favorite Tracks From Cd Onto A Single Tape (Program Edit Recording) - Kenwood XD-8550/8050 Instruction Manual

5 4
Recording favorite tracks from CD onto a single tape
(Program edit recording)
Use the following procedure to record CD tracks in the order programmed by yourself so that no tune is interrupted in the
middle at the ends of tape sides.
The tune interrupted at the end of tape side A is erased and side B starts from the beginning of that tune.
When equalizer, SRS 3D or another effect is applied
to the sound, the sound with the applied effect can
be recorded.
Recording preparations are required. ¤
1
Press so that the "PGM" indicator lights.
2
Enter disc Nos. and track Nos. in the order you want to record them. (Editing)
1 Enter the disc No. (DP-MH5 only)
2 Enter the track No.
3 Press the P.MODE key to enter the
For XD-6000:
Program other tracks by repeating steps 2 and 3 for each.
For XD-8550:
If you program tracks from more than one CD, repeat steps 1
to 3 for each.
To check the edited contents
To clear the edited contents
3
Start edit recording.
O p π
1. When the CCRS key is pressed during playback of CD, the playback stops and the CCRS setting (preparation for edited recording) starts.
2. Edit recording is not possible with CDs containing a track that is longer than one tape side, which may occur with classical music, etc.
Notes Notes
3. If the deck is set for one-side recording ("), the processing at the tape end is applied only on side A.
OP
¤ ¤
¤ ¤
P.MODE
DISC SKIP
Go to step 2 within 8 seconds.
1 2 3
4 5 6
7 8 9
PTY
SEARCH
0 +10
selection in memory.
Blinks
CCRS
Character information indicators cannot be displayed while
Note Note the spectrum analyzer display is used. Switch to the dual
display or character display mode to see the information.
For the reverse mode, select " " "," [ " (two-way recording).
The selected disc number is dis-
played when the DP-MH5 is used.
PGM MEMO EDIT
AUTO DISC
TUNED STEREO
MAX
Go to step
Press the numeric keys as shown below....
3 within
To enter track No. 23 : 003
8 seconds.
To select track No. 40 : 0000)
Select CD tracks so that their total playing time does not exceed the
recording time of the tape.
Up to 32 tracks can be programmed. When "FULL" is displayed, no
more tracks can be programmed.
If you make a mistake, press the CLEAR key and enter the track No.
from the beginning.
When the P.MODE key is pressed without selecting a title after
selection of a disc, all titles of the disc are programmed, so that the
CCRS function does not operate. Please begin again from step 1.
The REPEAT key is invalid.
Y
Y
During recording: X-H5
The recording level and bias will be adjusted automatically in approx. 60
seconds (variable depending on CD contents), after which recording
starts.
For XD-8550: In editing from more than one CD, the CCRS setting
operation is performed after every disc change. In this case, the deck stops
automatically and restart recording after having completed the CCRS
operation.
Lights
PGM MEMO EDIT RDS EON
C D *
AUTO DISC ALL
TUNED STEREO
MAX
SLEEP
Track No.
Program No.
RDS EON TA NEWS INFO. TP PTY TOTAL SPACE
C D * ) 3 * P - )
ALL
Blinks Lights
CCRS REC / ARM
Convenient CD recording
XD-8550/XD-6000 (En/T)
!´
TA
O.T.T
PROG. MUTE N.B.
: 1
12
5
4
3
kHz 2
1
MHz
9 10
7 8
6
11 12
13 14 15