Table of Contents
Advertisement
3.
DESCRIPTION OF MECHANISM
OPERATIONS
3.1
Magazine Set Section
3.1.1
Outline
This equipment is able to mount up to two magazines by mounting the sheet-feeder
unit. There are two types of magazines; large magazine for 35 x 43 cm film and small
magazine for 26 x 36 cm/20 x 25 cm film. With the small magazine, film size can be
switched between 26 x 36 cm and 20 x 25 cm size by changing the position of the
partition plate. By mounting the optional 25 x 30 cm film kit, 25 x 30 cm size films can
also be used.
The size of film used can be switched by the user by changing the magazine, and up
to seven magazines can be used.
Films are loaded onto resin sealed type magazines at the center. The magazine
shutter opens and closes together with the movement of the suction cup arm and films
are removed one at a time.
This magazine can be replenished with films without having to remove it from the
equipment.
016-201-04E
02.15.2007 FM5075
3.1.2
Magazine Detection/Magazine Number
Identification
The presence of magazines is detected by the film size detection sensors (upper:
SA11/SA12/SA13, lower: SA21/SA22/SA23).
When a magazine is inserted into the equipment, the actuators attached to the
magazines turn ON the sensors to detect them.
The attached position of these actuators can be varied between magazine No. 1 to 7.
(service setting)
When a magazine is inserted into the equipment, the magazine number is identified
from the combination of the ON/OFF status of the three film size detection sensors.
Magazine No.
SA11/SA21
No magazine loaded
OFF
Magazine No. 1
ON
Magazine No. 2
OFF
Magazine No. 3
ON
Magazine No. 4
ON
Magazine No. 5
ON
Magazine No. 6
OFF
Magazine No. 7
OFF
DRYPIX 2000 Service Manual
MD-20
Sensor
SA12/SA22
SA13/SA23
OFF
OFF
OFF
OFF
ON
OFF
OFF
ON
ON
OFF
ON
ON
ON
ON
OFF
ON
MD-20
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
