Printer - FujiFilm DRYPIX 2000 Service Manual

2.3.1

Printer

Error
Error Name
Code
Conveyance system file
0201
error
0202
FPMC error (At start)
0203
FPMC error (At stop)
FPMC error (No response
0204
at cancellation)
Initialization head HP
0218
deviation detection error
Initialization head HP
0219
return detection error
016-201-04E
02.15.2007 FM5075
Significance
Conveyance system related external file
access error
• File read error
• File write error
• File conversion error
• File line specification error
• File column specification error
• Size specification error
• External file data error
FPMC status is error during motor drive.
FPMC status is error status when motor
is stopping.
Stop response is not issued from the
driver when motor drive is stopped.
At initialization, attempted to deviate
head position from HP, but SH1 does not
become OPEN.
(Retryover)
At initialization, attempted to return head
position to HP, but SH1 does not become
CLOSE.
(Retryover)
Probable Cause and Remedy
The CF memory card is not set in the CPU board properly, or the card is
defective or CPU board malfunction.
Or data is inappropriate, or data is insufficient.
1. Set the card properly in the CPU board.
2. Replace the card with a new one.
3. Replace the CPU board.
4. Reinstall the software and check again.
Conflict in processing at CAN communication mechanism.
Conflict in processing at CAN communication mechanism.
Conflict in processing at CAN communication mechanism.
Malfunction of SH1 sensor or MH1 motor.
Or mechanism error, malfunction of CAN communication mechanism or SND
board SH1 port, MH1 controller.
1. Using the M-Utility, check sensors, motors, and perform mechanism
adjustments.
2. If the problem still persists, replace sensors/motors.
3. If the problem still persists, replace the SND board.
Malfunction of SH1 sensor or MH1 motor.
Or mechanism error, malfunction of CAN communication mechanism or SND
board SH1 port, MH1 controller.
1. Using the M-Utility, check sensors, motors, and perform mechanism
adjustments.
2. If the problem still persists, replace sensors/motors.
3. If the problem still persists, replace the SND board.
DRYPIX 2000 Service Manual
MT-10
Detailed Information
Format
2-B-1
2-C-1
2-C-1
2-D-1
2-A-4
2-A-4
MT-10