Annotation Font; Annotation Extend - FujiFilm DRYPIX 2000 Service Manual

[PC3-4-6] Annotation
Set and enter the character string of the annotation to be printed on film.
<NOTE>
If annotation is set even though the extension format has been set, the following
error message will be displayed. (Main unit software version V2.4 or later)
"Because 'Extension Format ID' is set, 'Annotation' cannot be set."
{MU:4.4 [PC3-4-1-10]_Extension Format ID}
[PC3-4-6-1]

Annotation Font

<FUNCTION>
Command for setting the font type of the annotation.
<OPERATIONS>
1.
Select the font.
• [0: Japanese]
• [1: Western]
2.
[Execute]
3.
Reboot the equipment.
[PC3-4-6-2]

Annotation Extend

<FUNCTION>
Command for setting the extension of the printing area of annotations along the height
of the characters.
<NOTE>
Use of this function is prohibited.
016-201-05E
03.31.2008 FM5332
[PC3-4-6-3] Upper Left/Upper Center/Upper Right/Lower Left/Lower
Center/Lower Right
<FUNCTION>
Select the place for entering the annotation text, and enter the annotation text
character.
<OPERATIONS>
1.
Select the place for entering the annotation text.
• [Upper Left] : Character string printed on the upper left corner of the film
• [Upper Center] : Character string printed on the top of the film in the center
• [Upper Right] : Character string printed on the upper right corner of the film
• [Lower Left] : Character string printed on the lower left corner of the film
• [Lower Center] : Character string printed on the bottom of the film in the center
• [Lower Right] : Character string printed on the lower right corner of the film
<NOTE>
• If annotations are set, the image area will be smaller than when
annotations are not set, and image will be printed in reduced size.
• Though annotations can be printed anywhere (upper/lower, left/ center/
right of the film), they may be missing at some locations. Therefore when
printing annotations at several locations, check that none is missing
during printing.
2.
Enter the annotation text character in the [Value] string.
<REMARKS>
• Up to 64 one-byte size characters can be entered.
• In addition to standard characters, macros are also available.
• If the annotation character string becomes long after macro conversion, make
sure that no characters are missing.
3.
[Execute]
4.
Reboot the equipment.
DRYPIX 2000 Service Manual
MU-98
MU-98