3.
Initializing IP Address
To initialize the IP address of the equipment, perform the following procedure.
1.
Turn OFF the power of the equipment.
2.
Remove the control box cover.
{MC (DRYPIX
Lite):10.2_Control Box}
3.
Turn ON the dip switch No.1 of S1 on the SND board.
S1
4
3
2
1
ON
4.
Install the control box cover.
{MC (DRYPIX
Lite):10.2_Control Box}
5.
Connect network cable of the PC for servicing to the network to which
the equipment is connected.
6.
Turn ON the power of the equipment.
7.
Start the PC-Utility.
{MU (DRYPIX
Lite):3.2.2_Connecting the PC for Servicing to the
Equipment (Starting PC-Utility)}
016-201-06E
01.27.2012 FM5920
S1
S1
4
3
2
1
ON
E0003.ai
8.
Check that the IP address has been reset to the default (172.16.1.30).
{MU (DRYPIX Lite):3.4
[PC1-1-3-1]_IP Address}
9.
End the PC-Utility.
{MU (DRYPIX
Lite):3.2.4_Disconnecting the Equipment}
10.
Turn OFF the power of the equipment.
11.
Remove the control box cover.
{MC (DRYPIX
Lite):10.2_Control Box}
12.
Turn OFF the dip switch No.1 of S1 on the SND board.
S1
S1
4
3
2
1
ON
13.
Install the control box cover.
{MC (DRYPIX
Lite):10.2_Control Box}
DRYPIX Lite Service Manual
MT-53
S1
4
3
2
1
ON
E0004.ai
MT-53