Using Ekip Bluetooth-Module - ABB TruONE ATS Installation And Operating Instruction

3 4 O X _ 3 0 - 1 6 0 0 r e v. B / 1 S C C 3 0 3 0 1 1 M 0 2 0 1
—

5.2 Using Ekip Bluetooth-module

The Ekip Bluetooth allows connection via
Bluetooth between the automatic trans-
fer switch and a support (PC, tablet, or
smart phone) with the Ekip Connect soft-
ware installed (see the previous para-
graph). Ekip Bluetooth -module is suitable
to use with all TruONE automatic transfer
switches.
Information
The Ekip Bluetooth module can be used with-
out powering the mains. (Local Bus Accesso-
ries, including HMI, are not operative).
—
Fig. 5.4 Ekip Bluetooth-module
It draws its power from a rechargeable
lithium-polymer battery supplied with the
unit. It is connected directly to the pro-
gramming port (see Fig. 5.6) and allows
the controller without auxiliary voltage to
be powered. The programming port can
only be used with Ekip Bluetooth and Ekip
Programming -modules.
Note
Ekip Bluetooth only powers the controller
(HMI and modules excluded). Therefore, in
order to recognize all connected modules
with Ekip Connect, the auxiliary power
supply module, type OXEA1, must be used
(see chapter 5.4).
5.2.1 Signallings
Ekip Bluetooth -module is switched on by
pressing the power button on the side,
and is equipped with two LEDs:
• The first lit in green with the device on
and the battery charge, red with the de-
vice turned on and low battery.
• The second flashing blue with active
Bluetooth communication.
75