ABB TruONE ATS Installation And Operating Instruction page 84

84 Tr u O N E ® AT S , I N S TA L L AT I O N A N D O P E R AT I N G I N S T R U C T I O N
5.6.1.3 Access from the display /
Ekip Com Modbus RTU –module
With modules energized the presence of
the modules on the module slot activates
additional menus on the display.
The following table illustrates the path for
accessing the configuration parameters
of the modules from the display:
Settings (*Default value)
:
Modules (Optional modules)
Ekip Com Modbus RTU
Serial address
Baudrate
Physical protocol
:
—
Table 5.7 The path for accessing the configuration parameters of the Ekip Com Modbus RTU -module from the display
The following table illustrates the path
from the display for accessing informa-
tion on the module:
About
:
Modules (Optional modules)
Ekip Com Modbus RTU
SN
Version
:
—
Table 5.8 Information of Ekip Com Modbus RTU -module in HMI
1... 247, default 247*
9600 bit/s, 19200 bit/s*,
38400 bit/s
8.E,1*, 8.O,1, 8.N,2, 8.N,1
Description
Address to be assigned to the modules.
NOTE: devices connected to the same network
must have different addresses
Data transmission speed
8.E,1 = 8 data bits, 1 EVEN parity bit, 1 STOP bit
8.O,1 = 8 data bits, 1 ODD parity bit, 1 STOP bit
8.N,2 = 8 data bits, no parity bit, 2 STOP bits
8.N,1 = 8 data bits, no parity bit, 1 STOP bit
Description
Serial number
Software version