ABB TruONE ATS Installation And Operating Instruction page 107

3 4 O X _ 3 0 - 1 6 0 0 r e v. B / 1 S C C 3 0 3 0 1 1 M 0 2 0 1
The following table illustrates the path
from the display for accessing informa-
tion on the module:
About
:
Modules (Optional modules)
Ekip Com IEC 61850
SN
Version
IP Address
Network Mask
Gateway Address
TCP Client
MAC Address
:
Organizationally Unique Identifier, formed from the first three bytes of a MAC address, and which
1)
uniquely identifies the manufacturer of an Ethernet device.
—
Table 5.29 Information of Ekip Com IEC 61850 -module in HMI
Description
Serial number
Software version
This is the address assigned to the modules at the
moment of connection to the network. It consists
of four bytes (for a total of 32 bits), each of which
can have value from 0 to 255. By default, allocation
is dynamic. With dynamic allocation, the modules
wait to receive the IP address from a DHCP server.
Without a DHCP server, the modules adopt an
Autoconfiguration IP Address in the range
169.254.xxx.xxx, calculated in a pseudo random
manner so as to be the same at every switch-on.
Alternatively, you can enable the static IP address
option, which allows the IP address to be forced. In
this case, you must make sure that the IP Address
inserted is different to that of the other devices
connected to the same network.
This is the subnet mask, and identifies the method
to recognize the subnet to which the modules
belong, with the possibility of searching for the
modules within a defined set of recipients. If you
enabled the option Static IP Address, you must
also enter the correct Network Mask.
The IP address of the node to which the module it
is connected, in the presence of multiple subnets.
If you enabled the Static IP Address option, you
must also enter the correct Gateway Address.
There are three IP Addresses of the client devices
connected to the modules.
It is the address assigned by ABB, having a OUI
equal to ac:d3:64 .
1)
107