ABB TruONE ATS Installation And Operating Instruction page 110

110 Tr u O N E ® AT S , I N S TA L L AT I O N A N D O P E R AT I N G I N S T R U C T I O N
5.6.8.2 Access from the display
/ Ekip Com Hub
With modules energized the presence of
the modules on the module slot activates
additional menus on the display:
• To set the addressing of the modules.
• In order to display information on the
modules.
The following table illustrates the path
from the display, for setting the function
and addressing of the modules:
Settings (*Default value)
:
Modules (Optional modules)
Ekip Com Hub
Enable
Force Static IP address
Static IP Address
Network Mask Static
Static Gateway addr
SNTP Client Enabled
SNTP Server Address
Password
Remote firmware update
:
—
Table 5.32 The path for setting the function and addressing of the modules of the Ekip Com Hub -module from the display
Description
Off*
Switch communication between module and
server
On
Off* Dynamic IP address.
On Static IP address.
Se On all the associated parameters are enabled.
0.0.0.0* Enables the static IP to be selected.
0.0.0.0* Enables the subnet mask to be selected.
0.0.0.0* When there are several subnets, enables the IP
address of the node to which the module is
connected to be selected.
Off* Enables the SNTP protocol for distribution of the
clock and synchronization signal to be enabled.
On
0.0.0.0* Enables the network server that supplies the
SNTP to be set.
--- Code required to register module on cloud.
Enables the firmware of the module to be
updated.
OFF Automatic*
Enable To configure firmware download.
Automatic To automate module update.