ABB TruONE ATS Installation And Operating Instruction page 103

3 4 O X _ 3 0 - 1 6 0 0 r e v. B / 1 S C C 3 0 3 0 1 1 M 0 2 0 1
The following table illustrates the path
from the display for accessing informa-
tion on the module:
About
:
Modules (Optional modules)
Ekip Com EtherNet/IP
SN
Version
IP Address
Network Mask
Gateway Address
TCP Client
MAC Address
:
Organizationally Unique Identifier, formed from the first three bytes of a MAC address, and which
1)
uniquely identifies the manufacturer of an Ethernet device.
—
Table 5.25 Information of Ekip Com EtherNet/IP -module in HMI
Description
Serial number
Software version
This is the address assigned to the modules at the moment
of connection to the network. It consists of four bytes (for
a total of 32 bits), each of which can have value from 0 to
255. By default, allocation is dynamic. With dynamic
allocation, the modules wait to receive the IP address from
a DHCP server. Without a DHCP server, the modules adopt
an Autoconfiguration IP Address in the range 169.254.xxx.
xxx, calculated in a pseudo random manner so as to be the
same at every switch-on. Alternatively, you can enable the
static IP address option, which allows the IP address to be
forced. In this case, you must make sure that the IP Address
inserted is different to that of the other devices connected
to the same network.
This is the subnet mask, and identifies the method to
recognize the subnet to which the modules belong, with
the possibility of searching for the modules within a
defined set of recipients. If you enabled the option Static
IP Address, you must also enter the correct Network Mask.
The IP address of the node to which the module it is
connected, in the presence of multiple subnets. If you
enabled the Static IP Address option, you must also enter
the correct Gateway Address.
There are three IP Addresses of the client devices
connected to the modules.
It is the address assigned by ABB, having a OUI equal to
.
ac:d3:64 1)
103