Introduction; Purpose Of The Design Guide; Additional Resources; Document And Software Version - Danfoss VLT AQUA Drive FC 202 Design Manual

Introduction

1 1
1 Introduction

1.1 Purpose of the Design Guide

This design guide is intended for:
•
Project and systems engineers.
•
Design consultants.
•
Application and product specialists.
The design guide provides technical information to
understand the capabilities of the drive for integration into
motor control and monitoring systems.
®
VLT is a registered trademark.

1.2 Additional Resources

Other resources are available to understand advanced
drive operation, programming, and directives compliance.
•
The Operating Guide provides detailed
information for the installation and start up of
the drive.
•
The Programming Guide provides greater detail on
how to work with parameters and includes many
application examples.
•
The VLT
describes how to use Danfoss drives in functional
safety applications. This manual is supplied with
the drive when the safe torque off option is
present.
•
The VLT
describes how to select the optimal brake resistor.
•
Optional equipment is available that can change
some of the information described in these
publications. Be sure to see the instructions
supplied with the options, for specific
requirements.
Supplementary publications and manuals are available
from Danfoss. See drives.danfoss.com/knowledge-center/
technical-documentation/ for listings.
4
VLT® AQUA Drive FC 202
®
Safe Torque Off Operating Guide
®
MCE 101 Brake Resistor Design Guide
Danfoss A/S © 05/2017 All rights reserved.

1.3 Document and Software Version

This manual is regularly reviewed and updated. All
suggestions for improvement are welcome. Table 1.1 shows
the document version and the corresponding software
version.
Edition Remarks
MG22B1xx Initial release
Table 1.1 Document and Software Version

1.4 Conventions

•
Numbered lists indicate procedures.
•
Bullet lists indicate other information and
description of illustrations.
•
Italicized text indicates:
- Cross-reference.
- Link.
- Footnote.
- Parameter name, parameter group
name, parameter option.
•
All dimensions in drawings are in mm (in).
•
An asterisk (*) indicates a default setting of a
parameter.
Software version
2.70
MG22B102