Siemens SINAMICS G130 Engineering Manual page 177

Terminal block on TM31
Factory setting
-X541 Bidirectional inputs/outputs
DI/DO8 Message: Ready to start
DI/DO9 Not assigned
DI/DO10 Not assigned
DI/DO11 External alarm
-X542 Relay outputs (changeover contact)
DO0 Inverter enable (Run)
DO1 Checkback signal No converter fault
-X521 Analog inputs, differential
AI0+ Not assigned
AI0-
AI1+ Not assigned
AI1-
-X522 Analog outputs
AO 0V+
AO 0V- Analog output, actual speed value
AO 0C+
AO 1V+
AO 1V- Analog output, actual motor current value
AO 1C+
-X522 Thermistor protection
+Temp
-Temp
The factory settings of the bidirectional inputs/outputs are underscored.
1)
Engineering Information
Comment
Factory-set as input
Factory-set as input
Factory-set as input
The factory setting for the outputs is 0 to 10 V.
The factory setting for the outputs is 0 to 10 V.
Input for KTY84 temperature sensor or PTC thermistor
SINAMICS Engineering Manual - May 2008
© Siemens AG
SINAMICS G130
177/396