Factory Settings (Defaults) Of Customer Interface On Sinamics G130 - Siemens SINAMICS G130 Engineering Manual

SINAMICS G130
Engineering Information
█

Factory settings (defaults) of customer interface on SINAMICS G130

The following factory settings are provided to simplify configuring of the customer interface and commissioning. The
interfaces can also be assigned as required at any time.
1. The converter is controlled via the PROFIBUS interface which is integrated as standard. The digital inputs and
outputs on the Control Unit are used to incorporate external alarm and/or error messages and control signals.
Terminal block on CU320
-X122 Factory setting
DI0 Not assigned
DI1 Not assigned
DI2 Not assigned
DI3 Acknowledge fault
M1
M1
DI/DO8 Inverter enable (Run)
DI/DO9 No fault
M (GND)
DI/DO10 P24
DI/DO11 External alarm
M (GND)
-X132
DI4 OFF 2
DI5 OFF 3
DI6 External fault
DI7 Not assigned
M (GND)
DI/DO12 Error message acknowledgement, Braking
Module
DI/DO13 P24
M (GND)
DI/DO14 P24
DI/DO15 P24
M (GND)
The factory settings of the bidirectional inputs/outputs are underscored.
1)
A jumper should be inserted here if these inputs are not used.
SINAMICS Engineering Manual – May 2008
174/396
© Siemens AG
1)
1)
1)
1)
Comment
Factory-set as output
Low active
Ramp-down along quick-stop ramp, only of relevance in
conjunction with the Braking Module
Output is used (factory-set) in conjunction with the Braking
Module
Factory-set as output
Factory-set as output
Factory-set as output