Factory Settings (Defaults) Of Customer Interface On Sinamics G150 - Siemens SINAMICS G130 Engineering Manual

█

Factory settings (defaults) of customer interface on SINAMICS G150

The following factory settings are provided to simplify configuring the customer interface and commissioning. The
interfaces can also be assigned freely at any time.
Terminal block on TM31
Factory setting
-X520 Optocoupler inputs connected to common
potential
DI0 ON/OFF 1
DI1 Increase setpoint/fixed setpoint 0
DI2 Decrease setpoint/fixed setpoint 1
DI3 Acknowledge fault
-X530 Optocoupler inputs connected to common
potential
DI4
Inverter enable
1)
DI5 OFF 3
DI6 External fault
DI7
-X541 Bidirectional inputs/outputs
DI/DO8 Message: Ready to start
DI/DO9 Not assigned
DI/DO10 Not assigned
DI/DO11 Not assigned
-X542 Relay outputs (changeover contact)
DO 0 Inverter enable (Run)
DO 1 Checkback signal No converter fault
-X521 Analog inputs, differential
AI0+ Analog input for setting speed setpoint
AI0-
AI1+ Analog input reserved
AI1-
-X522 Analog outputs
AO 0V+
AO 0V- Analog output, actual speed value
AO 0C+
AO 1V+
AO 1V- Analog output, actual motor current value
AO 1C+
-X522 Thermistor protection
+Temp
-Temp
The factory settings of the bidirectional inputs/outputs are underscored.
1)
A jumper must be inserted here if these inputs are not used
1)
1)
Engineering Information
Comment
Parameters can be set in the firmware to determine whether
operation is via motorized digital potentiometer or fixed setpoint
Converter is at standby and waiting for the enable signal
Ramp-down along quick-stop ramp, only of relevance in
conjunction with the Braking Module
Factory-set as input
Factory-set as input
Factory-set as input
The factory setting for the inputs is 0 to 20 mA.
The factory setting for the inputs is 0 to 20 mA.
The factory setting for the outputs is 0 to 20 mA.
The factory setting for the outputs is 0 to 20 mA.
Input for KTY84 temperature sensor or PTC thermistor
SINAMICS Engineering Manual - May 2008
SINAMICS G150
191/396
© Siemens AG