YASKAWA GPD 515/G5 Modbus RTU Technical Manual page 34

Typical CRC-16 Calculation Program in Quick Basic:
crcsum# = &HFFFF&
crcshift# = &H0&
crcconst# = &HA001&
CLS
PRINT "***************************************************"
PRINT
PRINT " CRC-16 calculator"
PRINT
PRINT "***************************************************"
PRINT "If entering data in hex, preceed the data with '&H'"
PRINT " Example: 32decimal = 20hex = &H20"
PRINT "***************************************************"
PRINT
INPUT "Enter the number of bytes in the message: ", maxbyte
FOR bytenum = 1 TO maxbyte STEP 1
PRINT "Enter byte "; bytenum; ":":
INPUT byte&
byte& = byte& AND &HFF&
crcsum# = (crcsum# XOR byte&) AND &HFFFF&
FOR shift = 1 TO 8 STEP 1
crcshift# = (INT(crcsum# / 2)) AND &H7FFF&
IF crcsum# AND &H1& THEN
crcsum# = crcshift# XOR crcconst#
ELSE
crcsum# = crcshift#
END IF
NEXT shift
NEXT bytenum
lower& = crcsum# AND &HFF&
upper& = (INT(crcsum# / 256)) AND &HFF&
PRINT "Lower byte (1st) = ", HEX$(lower&)
PRINT "Upper byte (2nd) = ", HEX$(upper&)
6-14 The Message Format