YASKAWA GPD 515/G5 Modbus RTU Technical Manual page 54

Drive Parameter Registers (Read/Write) (continued)
REGISTER PARAMETER
(in hex)
313h E2-06
314h E2-07
315h E2-08
316h E2-09
317h E3-01
318h E4-01
319h E4-02
31Ah E4-03
31Bh E4-04
31Ch E4-05
31Dh E4-06
31Eh E4-07
31Fh E5-01
320h E5-02
321h E5-03
322h E5-04
323h E5-05
324h E5-06
Notes (for this page only):
1. Initial value differs depending on the Control Method (A1-02).
2. Initial value differs depending on drive capacity (o2-04).
7-18
PARAMETER
FUNCTION
Motor Leakage Inductance
Motor Iron-core Saturation Coefficient 1
Motor Iron-core Saturation Coefficient 2
Motor Mechanical Loss
Motor 2 Control Method Selection
Motor 2 Max. Output Frequency
Motor 2 Maximum Voltage
Motor 2 Max. Voltage Frequency
Motor 2 Mid. Output Frequency
Motor 2 Mid. Output Freq. Voltage
Motor 2 Min. Output Frequency
Motor 2 Min. Output Freq. Voltage
Motor 2 Rated Current
Motor 2 Rated Slip
Motor 2 No-Load Current
Motor 2 Number of Poles
Motor w Line-to-Line Resistance
Motor 2 Leakage Inductance
PARAMETER LIMITS / DESCRIPTION
SETTING
0.0 to 30.0%
0.00 to 0.50
0.00 to 0.75
0.0 to 10.0%
0
1 V/f with PG Feedback
2 Open Loop Vector
3
50.0 to 400.0 Hz
0.0 to 255.0V (230V unit)
0.0 to 510.0V (460V unint)
0.0 to 400.0 Hz
0.0 to 400.0 Hz
0.0 to 255.0V (230V unit)
0.0 to 510.0V (460V unint)
0.0 to 400.0 Hz
0.0 to 255.0V (230V unit)
0.0 to 510.0V (460V unint)
0.00 to 99.99 or 100.0 to 1500.0 Amps
0.00 to 20.00 Hz
0.00 to 99.99 or 100.0 to 1500.0 Amps
2 to 48 poles
0.000 to 65.000 Ohms
0.0 to 30.0%
Registers
INITIAL
VALUE
V/f Control
Flux Vector
230.0
460.0
(2)
0.50
0.75
0.0
2
7
60.0
(1)
(1)
(1)
(1)
(2)
(2)
(2)
4
(2)
(2)