Siemens SINUMERIK 840D sl Commissioning Manual page 74

7 Machine Data
7.2 Display machine data for ShopTurn
9863
MD number
Standard value: 5
Change becomes effective after: IMMEDIATELY
Data type: DOUBLE
Significance:
9897
MD number
Standard value: 8
Change becomes effective after: IMMEDIATELY
Data type: LONG
Significance:
9898
MD number
Standard value: H7000
Change becomes effective after: IMMEDIATELY
Data type: LONG
Significance:
7-74
$MM_ST_MAX_INP_AREA_GAMMA
Maximum input area for gamma alignment angle
Min. input limit: 0
Protection level: 3/4
This MD is used to specify the maximum input area for the gamma alignment angle.
The value acts as a +/– area for the angle values 0° and 180°.
$MM_ST_OPTION_MASK_MAN_FUNC
Settings for ShopTurn manual functions
Min. input limit: –
Protection level: 3/4
Bit 0 = 0: Control of main spindle via machine control panel
Bit 0 = 1: Control of main spindle via operator interface
Bit 1 = 0: Control of tool spindle via machine control panel
Bit 1 = 1: Control of tool spindle via operator interface
Bit 2: Reserved
Bit 3 = 0: Manual taper turning hidden
Bit 3 = 1: Manual taper turning displayed
$MM_ST_OPTION_MASK
Settings for ShopTurn
Min. input limit: 0000
Protection level: 1
Bit 0 = 1: Enable machining "internal/rear" in screens that define the machining level them-
selves.
Bit 1 to bit 5: Reserved
Bit 6 = 1: Allow simultaneous recording despite program start.
Bit 7 and bit 8: Reserved
Bit 9 = 1: Disable entering an offset in X in the zero offset list.
Bit 10 = 1: Display program view under simultaneous recording.
Bit 11 = 0: After reset, retain currently active zero offset.
Bit 11 = 1 and MD 20152[7] = 0: After reset, the zero offset which is entered in menu "T, S,
M" remains effective.
Bit 12 = 1: Enable "Plunge–turning" and "Plunge–turning residual material" functions.
Bit 13 = 1: Enable "Plunge–cutting" and "Plunge–cutting residual material" functions.
Bit 14 = 1: Allow negative final machining allowance for contour turning.
Bit 15 = 1: Counterspindle: Allow internal/external clamping.
Bit 16 = 1: Measure tools with probe: Additional probe on counterspindle.
Bit 17 = 1: Tool measurement for rotating tools with rotating spindle
Bit 18 = 1: Display column "Rotation" in the zero offset list.
Bit 19 to bit 21: Reserved
Bit 23 to 24: Reserved
Bit 25: A full cross–section of the side view is always displayed in the simulation.
SINUMERIK 840D sl Commissioning Manual CNC: ShopTurn – 11/2006 Edition
Max. input limit: 90
Units: –
Valid as of software version
ShopTurn 7.2
Max. input limit: –
Units: –
Valid as of software version
ShopTurn 7.1
Max. input limit: FFFF_FFFF
Units: Hex
Valid as of software version
ShopTurn 7.1
© Siemens AG 2006 All Rights Reserved
11/2006