Configuring The Operator Interface - Siemens SINUMERIK 840D sl Commissioning Manual

8 Tool Management
8.8

Configuring the operator interface

8.8 Configuring the operator interface
8.8.1 Integrating additional list
8-110
There are two ways you can modify the existing operator interface for the tool
management system:
S
In tool management, in addition to the tools, wear, and magazine lists, an
additional list can also be activated on the 3rd horizontal softkey; (see sec-
tion 8.8.1 "Integrating additional list").
S
In these lists, depending on the tool, all existing or user–defined parameters
can be configured; (see section 8.8.2 "Modifying lists").
To activate an additional list proceed as follows:
S
Set machine data
9478 $MM_TO_OPTION_MASK, Bit 2 = 1
Activate additional list
In tool management you can now, by means of the 3rd horizontal softkey,
call up a list with the following parameters :
– "Length Y"
– "Wear length Y"
– "H number" .
Parameter "H number" will only be displayed if ShopTurn is set up for ISO
dialects (see section 11.4 "ISO dialects").
S
Specifying texts for additional list (optional)
If you want to change the softkey label (OEM tool list) and header (OEM tool
list) of the additional list, you must define new texts (see chapter 8.8.7
"Defining texts").
SINUMERIK 840D sl Commissioning Manual CNC: ShopTurn – 11/2006 Edition
© Siemens AG 2006 All Rights Reserved
11/2006