Siemens SINUMERIK 840D sl Commissioning Manual page 37

11/2006
Table 6-1 Signals to ShopTurn (input signals)
Address
DB82
DBX
9.6 CMM_IN.disable_cnc_standard
Lock the switchover to CNC–ISO operator
interface
9.7 CMM_IN.cmm_activ_in_cnc_mode
ShopTurn PLC active during CNC–ISO
operation
10.0 CMM_IN.program_test_request
Select function for program test
10.1 CMM_IN.dry_run_request
Select the function DryRun
10.2 CMM_IN.m01_request
Select function M01
10.3 CMM_IN.skip_block_request
Select function for skipping record
10.4 CMM_IN.boot_standard
System boot in CNC–ISO operator interface
10.5 CMM_IN.nck_auto_req
Prepare record search PLC
10.7 CMM_IN.ignore_nck_alarm
Ignore NCK alarm in the event of cycle start
11.1 CMM_IN.get_tool_data
Update tools data
11.2 CMM_IN.c_axis_feed_drive
Separate feed drive as C axis drive
11.3 CMM_IN.select_spindle_readout_0
Select spindle speed display, bit 0
© Siemens AG 2006 All Rights Reserved
SINUMERIK 840D sl Commissioning Manual CNC: ShopTurn – 11/2006 Edition
Name
Comments
6.3 Overview of earlier ShopTurn interface
Spares
ShopTurn Open (PCU 50.3):
not available,
ShopTurn on NCU (HMI Embedded)
Assign protective levels to lock the remaining ope-
rator areas
Omitted because ShopTurn PLC no longer exists.
MMC –> PLC DB21.DBX25.7
PLC –> NCK DB21.DBX1.7
Connect as in the PLC user program.
MMC –> PLC DB21.DBX24.6
PLC –> NCK DB21.DBX0.6
Connect as in the PLC user program.
MMC –> PLC DB21.DBX24.5
PLC –> NCK DB21.DBX0.5
Connect as in the PLC user program.
MMC –> PLC DB21.DBX26.0 ff
PLC –> NCK DB21.DBX2.0 ff
Connect as in the PLC user program
ShopTurn Open (PCU 50.3):
Modify Powerontask in the schedule, or remove
the ShopTurn operating area from the schedule, or
assign a protective level to the ShopTurn oper-
ating area in the schedule.
ShopTurn on NCU (HMI Embedded):
Assign a protective level to the ShopTurn oper-
ating area.
Omitted because operating areas Jog, Automatic,
and MDA are now identical with the NCK oper-
ating modes
Omitted because the NCK start is no longer by
manipulated by ShopTurn
Omitted because the data is automatically updated
with the NCK function "Extended tool counter"
DB31ff.DBX56.0
DB31ff.DBX56.1
All bits 0: The main spindle rule applies
More than 1 bit active: The following sequence
applies:
1. Main spindle
2. Rotating tool spindle
3. Counterspindle
6 Signal Description
6-37