Siemens SINUMERIK 840D sl Commissioning Manual page 58

7 Machine Data
7.2 Display machine data for ShopTurn
9654
MD number
Standard value: 0
Change becomes effective after: IMMEDIATELY
Data type: BYTE
Significance:
9657
MD number
Standard value: 5
Change becomes effective after: IMMEDIATELY
Data type: WORD
Significance:
9658
MD number
Standard value: 0.01
Change becomes effective after: IMMEDIATELY
Data type: DOUBLE
Significance:
9663
MD number
Standard value: 1
Change becomes effective after: POWER ON
Data type: BYTE
Significance:
9664
MD number
Standard value: 10000.0
Change becomes effective after: IMMEDIATELY
Data type: DOUBLE
Significance:
7-58
$MM_CMM_SPEED_FIELD_DISPLA Y_RES
Number of decimal places in the speed input field
Min. input limit: 0
Protection level: 3/4
This MD is used to stipulate the number of decimal places in parameter field S (speed).
$MM_CMM_CYC_MIN_CONT_PO_T O_RAD
Variation of smallest possible cutter radius in %
Min. input limit: 0
Protection level: 3/4
This MD is required for milling contour pockets. This parameter is used to stipulate the
percentage by which the radius of the cutter being used may be smaller than the one used
for generation.
$MM_CMM_CYC_MAX_CONT_PO_T O_RAD
Variation of largest possible cutter radius
Min. input limit: 0.0
Protection level: 3/4
This MD is required for milling contour pockets. This parameter is used to stipulate the
amount by which the radius of the cutter being used may be larger than the one used for
generation.
$MM_CMM_TOOL_DISPLAY_IN_DIAM
Display radius/diameter for tool
Min. input limit: 0
Protection level: 3/4
This MD is used to stipulate the display/input format for the tool (only for milling and drilling
tools):
0 = Radius
1 = Diameter
$MM_CMM_MAX_INP_FEED_P_MIN
Maximum feed in mm/min
Min. input limit: 0.0
Protection level: 3/4
This MD is used to enter the upper limit for the feed rate input in mm/min.
SINUMERIK 840D sl Commissioning Manual CNC: ShopTurn – 11/2006 Edition
Max. input limit: 4
Units: –
Valid as of software version
ShopTurn 6.1
Max. input limit: 50
Units: %
Valid as of software version
ShopTurn 6.1
Max. input limit: 10.0
Units: mm
Valid as of software version
ShopTurn 6.1
Max. input limit: 1
Units: –
Valid as of software version
ShopTurn 6.1
Max. input limit: 100000.0
Units: mm/min
Valid as of software version
ShopTurn 6.1
© Siemens AG 2006 All Rights Reserved
11/2006