Creating And Loading The Configuration File - Siemens SINUMERIK 840D sl Commissioning Manual

8 Tool Management
8.3 Start- -up in NCK
8.3.3

Creating and loading the configuration file

Example
8-88
For tool management start--up a configuration file for the turret must be created
and loaded in the NCK.
Create a new configuration file or adapt the example from the toolbox.
Note
Make sure that you adapt the data in the configuration file to match the
machine data for tool management.
The configuration file must include the following settings:
Define the type of search strategy
S
S Define the real magazine
Define buffer magazine
S
Define load magazine
S
Define locations for the real magazine
S
S Define locations for the buffer magazine
S Define the spindle assignment
Define the locations for the load magazine
S
Define the distances for the real magazine
S
Transfer the configuration file to the NCK.
The configuration file TM_REV12.8x0 is located in the PLC toolbox under
\ShopMill_Turn and has been generated for a turret magazine with 12 locations,
1 tool holder, and 2 loading points.
Enter the value 15 in MD 18086 $MN_MM_NUM_MAGAZINE_LOCATION.
Adapt configuration file TM_REV.12.8X0 at the positions marked bold.
%_N_TO_TMA_INI
CHANDATA(1)
;--------------------------------------------------------------
;TM_REV.12.8x0
;
;tool management configuration for ShopTurn machine with turret
;--------------------------------------------------------------
;delete old data
;---------------
SINUMERIK 840D sl Commissioning Manual CNC: ShopTurn - - 11/2006 Edition
© Siemens AG 2006 All Rights Reserved
11/2006