Siemens SINUMERIK 840D sl Commissioning Manual page 59

11/2006
9665
MD number
Standard value: 1.0
Change becomes effective after: IMMEDIATELY
Data type: DOUBLE
Significance:
9666
MD number
Standard value: 1.0
Change becomes effective after: IMMEDIATELY
Data type: DOUBLE
Significance:
9667
MD number
Standard value: 0
Change becomes effective after: IMMEDIATELY
Data type: BYTE
Significance:
9668
MD number
Standard value: –1
Change becomes effective after: IMMEDIATELY
Data type: WORD
Significance:
© Siemens AG 2006 All Rights Reserved
SINUMERIK 840D sl Commissioning Manual CNC: ShopTurn – 11/2006 Edition
$MM_CMM_MAX_INP_FEED_P_ROT
Maximum feed in mm/rev
Min. input limit: 0.0
Protection level: 3/4
This MD is used to enter the upper limit for the feed rate input in mm/rev.
$MM_CMM_MAX_INP_FEED_P_T OOTH
Maximum feed in mm/tooth
Min. input limit: 0.0
Protection level: 3/4
This MD is used to enter the upper limit for the feed rate input in mm/tooth.
$MM_CMM_FOLLOW_ON_T OOL_ACTIVE
Tool preselection active
Min. input limit: 0
Protection level: 3/4
This MD is used to activate tool preselection in a magazine (e.g. chain magazine); i.e. the
following tool is already brought to the loading point for a pending tool change.
0 = Tool preselection is not active
1 = Tool preselection is active
Note: Tool preselection is not necessary for a turret revolver; i.e. the MD must be set to "0".
$MM_CMM_M_CODE_COOLANT_I_AND_II
M function coolant I and II
Min. input limit: –1
Protection level: 3/4
This MD is used to stipulate the M function if in the tools list coolants I and II are both active
at the same time.
Value:
–1 = No M function
xy = M function xy for coolant I and II
7.2 Display machine data for ShopTurn
Max. input limit: 10.0
Valid as of software version
ShopTurn 6.1
Max. input limit: 5.0
Valid as of software version
ShopTurn 6.1
Max. input limit: 1
Valid as of software version
ShopTurn 6.1
Max. input limit: 32767
Valid as of software version
ShopTurn 6.1
7 Machine Data
Units: mm/rev
Units: mm/tooth
Units: –
Units: –
7-59