Loading Setpoints From A File - GE MOTOR MANAGEMENT RELAY 469 Instruction Manual

8 469 PC SOFTWARE
An error message will occur when attempting to download a setpoint file with a revision num-
ber that does not match the relay firmware. If the firmware has been upgraded since saving
the setpoint file, see Section 8.3.5 UPGRADING SETPOINT FILES TO NEW REVISION on page
NOTE
8–9 for instructions on changing the revision number of the setpoint file.
Loading the 469 with setpoints from a file is accomplished as follows:
1. Select the File > Open menu item.
2. 469PC will launch the Open dialog box listing all filenames in the 469 default directory with the 469 exten-
sion. Select the setpoint file to download and click OK to continue.
3. Select the File > Send Info to Relay menu item. 469PC will prompt to confirm or cancel the setpoint file
load. Click Yes to update the 469 setpoints.
GE Power Management 469 Motor Management Relay
8.3 USING 469PC

8.3.3 LOADING SETPOINTS FROM A FILE

8
8-7