Voltage Metering; Speed - GE MOTOR MANAGEMENT RELAY 469 Instruction Manual

5 ACTUAL VALUES
S VOLTAGE METERING
S [ENTER] for more
Measured voltage parameters will be displayed here.
If no VT connection type is programmed for the S2 SYSTEM SETUP \ VOLTAGE SENSING \ VT CONNECTION TYPE set-
point, the following flash message will appear when an attempt is made to enter this group of messages.
THIS FEATURE NOT
PROGRAMMED
S SPEED
S [ENTER] for more
If the Tachometer function is assigned to one of the digital inputs, the tachometer readout may be viewed here.
If no digital input is configured as tachometer in S3 DIGITAL INPUTS \ ASSIGNABLE INPUT1/2/3/4, the following flash
message will appear when an attempt is made to enter this group of messages.
THIS FEATURE NOT
PROGRAMMED
GE Power Management
ð
Vab: 0 Vbc:
ENTER
Vca: 0 Volts
ESCAPE
AVERAGE LINE
ESCAPE
VOLTAGE: 0 Volts
MESSAGE
Van: 0 Vbn:
ESCAPE
Vcn: 0 Volts
MESSAGE
AVERAGE PHASE
ESCAPE
VOLTAGE: 0 Volts
MESSAGE
SYSTEM FREQUENCY:
ESCAPE
0.00 Hz
MESSAGE
ð
TACHOMETER: 0 RPM
ENTER
ESCAPE
469 Motor Management Relay
Range: 0 to 20000 V
0
Not seen if VT Connection is programmed as None
Range: 0 to 20000 V
Not seen if VT Connection is programmed as None
Range: 0 to 20000 V
0
Seen only if VT Connection is programmed as Wye
Range: 0 to 20000 V
Seen only if VT Connection is programmed as Wye
Range: 0.00, 20.00 to 120.00 Hz
Range: 0 to 3600 RPM
Seen only if a Digital Input is configured as Tachometer
5.3 A2 METERING DATA

5.3.3 VOLTAGE METERING

5.3.4 SPEED

5-11
5