Rtd Maximums - GE MOTOR MANAGEMENT RELAY 469 Instruction Manual

5.4 A3 LEARNED DATA
S RTD MAXIMUMS
S [ENTER] for more
5
The 469 will learn the maximum temperature for each RTD. This information can be cleared using the S1 469
SETUP \ CLEAR DATA \ CLEAR RTD MAXIMUMS setpoint.
If no RTDs are programmed in S8 RTD TEMPERATURE, the following flash message will appear when an attempt
is made to enter this group of messages.
THIS FEATURE NOT
PROGRAMMED
5-18
ð
RTD #1
ENTER
MAX. TEMP .: 40°C
ESCAPE
RTD #2
ESCAPE
MAX. TEMP .: 40°C
MESSAGE
RTD #3
ESCAPE
MAX. TEMP .: 40°C
MESSAGE
RTD #4
ESCAPE
MAX. TEMP .: 40°C
MESSAGE
RTD #5
ESCAPE
MAX. TEMP .: 40°C
MESSAGE
RTD #6
ESCAPE
MAX. TEMP .: 40°C
MESSAGE
RTD #7
ESCAPE
MAX. TEMP .: 40°C
MESSAGE
RTD #8
ESCAPE
MAX. TEMP .: 40°C
MESSAGE
RTD #9
ESCAPE
MAX. TEMP .: 40°C
MESSAGE
RTD #10
ESCAPE
MAX. TEMP .: 40°C
MESSAGE
RTD #11
ESCAPE
MAX. TEMP .: 40°C
MESSAGE
RTD #12
ESCAPE
MAX. TEMP .: 40°C
MESSAGE
469 Motor Management Relay
Range: –50 to 250°C, No RTD (open), ---- (shorted)
Seen only if at least 1 RTD programmed as Stator
Range: –50 to 250°C, No RTD (open), ---- (shorted). Not seen if
RTD set to None; reflects RTD Name as programmed
Range: –50 to 250°C, No RTD (open), ---- (shorted). Not seen if
RTD set to None; reflects RTD Name as programmed
Range: –50 to 250°C, No RTD (open), ---- (shorted). Not seen if
RTD set to None; reflects RTD Name as programmed
Range: –50 to 250°C, No RTD (open), ---- (shorted). Not seen if
RTD set to None; reflects RTD Name as programmed
Range: –50 to 250°C, No RTD (open), ---- (shorted). Not seen if
RTD set to None; reflects RTD Name as programmed
Range: –50 to 250°C, No RTD (open), ---- (shorted). Not seen if
RTD set to None; reflects RTD Name as programmed
Range: –50 to 250°C, No RTD (open), ---- (shorted). Not seen if
RTD set to None; reflects RTD Name as programmed
Range: –50 to 250°C, No RTD (open), ---- (shorted). Not seen if
RTD set to None; reflects RTD Name as programmed
Range: –50 to 250°C, No RTD (open), ---- (shorted). Not seen if
RTD set to None; reflects RTD Name as programmed
Range: –50 to 250°C, No RTD (open), ---- (shorted). Not seen if
RTD set to None; reflects RTD Name as programmed
Range: –50 to 250°C, No RTD (open), ---- (shorted). Not seen if
RTD set to None; reflects RTD Name as programmed
5 ACTUAL VALUES

5.4.3 RTD MAXIMUMS

GE Power Management